Hello all!

Below are some images of my latest DIY project. I did a RSBTR pre-cut Membrane silpoly hex tarp. This was a bit more challenging than I expected, just due to the super-thin slippery material. Just have to have a LOT of patience and go slow! I did the recommended Silnet reinforcements, but then realized some of them were separating from the Membrance material when pulled taut. So, I ran one radius stitch on each reinforcement along the edge. That seems to have resolved the issue. Let me know your thoughts! Some of you may recognized the fuscia reinforcements to match my "Gibson" double layer hammock....

Tarp 1.jpg
Tarp 2.jpg
Tarp 3.jpg
Tarp 4.jpg
Tarp 5.jpg
Tarp 6.jpg

The whole thing (tarp, lines, hardware, stakes and custom bag) are just over one pound. Not bad for this much coverage!! Thanks, RSBTR! Let me know what you all think and if you have any questions.