Probably a dumb question since no one else asked it but why does the center post need to be shifted down when attached to the hinge? They're all cut the same length, why not have them all attached at the same height?
another zombie reply to a post, but noticed nobody answered you when I was grabbing this link for a friend here at work. That keeps you from having to cut an angle in the top of the middle piece so it can open out - the two side uprights have to rotate inward when you set it up, so if the middle piece was all the way to the top, it would prevent that. An alternative is to put the middle bar on the outside of the hinge, but then the setup doesn't lay flat when folded up.
There was a comment earlier that he hadn't cut any angles in any of the three - that's partly what they were referring to.
no pics to help describe it here at work- hope this makes sense..
New to the forums. I love this stand. I'm off to Home Depot! Thanks!
Very nice, can't wait to make some of my own
So tarp over the ridgepole or under the ridgepole? Just curious, for a project I'm working on. Thanks.
Bookmarks