Hi, my new creation, works great so far.
https://makerworld.com/en/models/446...ofileId-353048
okIMG_0728.jpg
Hi, my new creation, works great so far.
https://makerworld.com/en/models/446...ofileId-353048
okIMG_0728.jpg
na paradu
Nice thx. Will give this a shot
That's very cool. I don't have a 3D printer, but our local public libraries have several where we can have projects printed out for a small nominal fee, basically the cost of material. I'm going to try it out with them.
Last edited by Crazytown3; 05-01-2024 at 15:23.
Definitely worth to try, I’m super happy with the result. Only thing is, these press-fit parts are sensitive to print quality and filament calibration. But you can always take a file or sharp blade and repair imperfections or scale the part a bit in slicing software if it is a too tight or loose. Depends a lot what printers they have and in what condition they are. I would be happy if you share feedback or ideas to improve!
Vanis, any chance you might be able to make to make this available as an stl file? My library only accepts the stl file format in the printing request.
Would you be willing to print and sell some?
Bookmarks