Results 1 to 4 of 4
  1. #1
    LowTech's Avatar
    Join Date
    Aug 2020
    Location
    Nomadic, US SW at moment
    Hammock
    one wind 11' wide
    Tarp
    one wind 12'
    Insulation
    SLD, UGQ, LL, JRB
    Suspension
    UCR
    Posts
    866

    Primary suspension mod?

    Just got my super quality, 50", habinaro UQ and have been looking at how to change the angle of the suspension lines by my head.
    Seems that the usually way is to have them go to the ridgeline which seems like it would be more out of my face than how it is. Unfortunately I haven't yet figured a way to do that w/o cutting the line and making it two loops, one from each side.
    Running a dogbone from the CL is not a problem, or even adding a pussic to the ridgeline, but I would have to thread the hammock through the UQ every time. Not only would that be a pain but it would be even harder using the fronkey net.

    Has anyone come up w/ a good way to do this mod w/o cutting the line?

  2. #2
    Phantom Grappler's Avatar
    Join Date
    Mar 2014
    Location
    Denton NC
    Hammock
    WildernessLogics 12x6
    Tarp
    HG cuben 13ridge12
    Insulation
    TopQuiltUnderQuilt
    Suspension
    S and D
    Posts
    4,926
    How does underquilt vendor say2 attach underquilt?
    Or are you gonna do a modification?

    Maybe attach underquilt suspension to end of hammock at continuous loop area.

    Then if needed, get a length of line to straddle hammock ridgeline and tie onto underquilt suspension, to help hold underquilt snug at hammock end—a known area for gaps and drafts.

    At point, your length of line straddles hammock ridgeline, you can attach with prusik.

    However you decide to proceed...
    If it works...it works

    If it don’t work, it’s Phantom’s fault

  3. #3
    LowTech's Avatar
    Join Date
    Aug 2020
    Location
    Nomadic, US SW at moment
    Hammock
    one wind 11' wide
    Tarp
    one wind 12'
    Insulation
    SLD, UGQ, LL, JRB
    Suspension
    UCR
    Posts
    866
    Quote Originally Posted by Phantom Grappler View Post
    How does underquilt vendor say2 attach underquilt?
    Or are you gonna do a modification?

    Maybe attach underquilt suspension to end of hammock at continuous loop area.

    If it don’t work, it’s Phantom’s fault
    It is meant to attach at the CLs, and yes, I'm wanting to do a mod. That's why I put that in the subject line.

    W/ it in the stock configuration the suspension lines are in my face more than I like.
    If I just pull the primary lines up to the ridgeline while leaving them connected at the CLs it gets super tight.
    If I add something to the CL (like a dogbone) so that I can hook it to the ridgeline and keep it from sliding (a prussic would work as well) then it starts to get complicated as one end of the hammock has to be disconnected and run between the two primary lines.

  4. #4
    Senior Member Rolloff's Avatar
    Join Date
    Dec 2010
    Location
    Leveland
    Hammock
    Bonefire Whisper
    Tarp
    HG DCF Hex
    Insulation
    Sheltowee JRB SS
    Suspension
    Bonefire
    Posts
    2,639
    I think you will need to shorten the suspension if you go the the SRL. I know I did, but I sent both ends of the suspension to the SRL, so maybe just not as short. I used Dutch's shock cord mitten hooks, but I suppose you could retie the suspension and move the knot off to one side or even into the channel on the UQ if large enough. You'd need to thread the single mitten hook on to the prussik and you could pack the hammock and UQ together to avoid having to "unthread" the two.
    Signature suspended

  • + New Posts
  • Similar Threads

    1. Primary suspension on incubator
      By Wmt90 in forum Bottom Insulation
      Replies: 4
      Last Post: 03-21-2019, 20:27
    2. UQ primary suspension - too long?
      By jtkratzer in forum Bottom Insulation
      Replies: 14
      Last Post: 03-18-2019, 10:49
    3. Primary Suspension Question
      By HillbillyHanger in forum Hammock Gear
      Replies: 8
      Last Post: 06-23-2017, 13:02
    4. Adjusting the primary suspension...
      By MikekiM in forum Hammock Gear
      Replies: 10
      Last Post: 02-04-2017, 13:38
    5. Zeppelin primary suspension too short?
      By punkisdead in forum UGQ Outdoor Equipment
      Replies: 5
      Last Post: 03-29-2015, 11:37

    Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •