Hey guys,
Just wondering if anyone has a suggestion for the depth of cat cuts for my tarp. I am making a rectangular tarp that will end up being a couple inches over 11ft long when finished. I am using 1.1 silpoly. I'm also thinking I'll add cat cuts on the vertical edges as well but not sure.
I made a similar tarp with silpoly xl and a 12 ft ridgeline a couple of years ago, and am fairly happy with it so I know I can figure it out but was wanting some input/suggestions.
My main reason for making this is because my favorite tarp is the Warbonnet cloudburst. I have 4-5 differently-shaped and high-quality tarps, but I almost always reach for the cloudburst when it's go time. I do wish it had some slight cat cuts to tighten it up a bit when pitched though.
Sent from my Moto Z (2) using Tapatalk
Bookmarks