Yeti suspension question

[MuadDale]

Looking at pictures, videos, and reviews I'm not seeing a secondary suspension on the Yeti under quilts, only the primary that goes from end to end.

Am I just not seeing it or is it designed that way as part of Warbonnets modular system? I think I know the answer but I've never seen one in person so I can't say for sure.

[Shug]

As far as I know it does not have a secondary suspension.
You could always add one as a mod though if needed.....https://youtu.be/sIiHN6Y88iw
Shug

[Treebird]

I have an older yeti, it has a continuous loop suspension so you can slide it foward or back.
It works well. Really simple.

[BillyBob58]

I have the original ( 2007? ) Climashield Yeti, to which I added a secondary, pretty easy to do. You might have to sew on a few Gros Grain or ribbon loops, then take a small loop of cord, make a Prussik knot around the main Yeti suspension, then connect that to the loop you sewed on. It s about as easy as mods get. It will work just as well as any other.

[Pooterball]

I have a yeti that I use on a diy hammock. I've never had a problem getting to to stay in place. I may have to adjust it if I move around a lot inside my hammock. It usually just needs pulled over my shoulder.

[MuadDale]

Thanks all! I'm guessing the lack of a secondary suspension on this particular quilt might be because it's designed for a specific hammock and it has a "draft collar" at each end sort of like the one on the Diamondback TQ that would seal up any small gaps.