What are people finding useful in guy length for the pullouts on this tarp?
What are people finding useful in guy length for the pullouts on this tarp?
If you want to use porch mode, you might want about 10'-12' lines on one side, to be safe. The other side can be shorter, like 4'-6'. Or you can make all 4 corners with the shorter length and carry a couple of extensions to use only when you want to set up in porch mode. For the doors, you can use even shorter lines, like 2'-3'.
For a standard deployment I use 4' on one side which is always set low as a wind/privacy wall. The other side uses 8' so it can be rigged in porch mode. Now for the panel pulls lots of different ways to rig but I prefer the external pole mod if not using an internal pole mode as most rigging methods are a PIA.
Sorry for the bad image below, best I could find this morning.
Thanks folks!
4'/8' mentioned above gets it done. I recently switched all mine to 6' all around, so I don't need to be limited to which side is "porch" side. 6' is always more than I need, but I like having a little extra.
Internal - End Pole Mod from UGQ is THE way to go. I'll gladly carry those 2 poles for the ability to go from a wide open Porch Mode View like above, to a hunkered down O-Chit mode w/in a minute, all without leaving the tarp.
I use Dutch Fleaz on my 4 corners and leave my cord locked into the fleaz and stored w/ the tarp. The other end of the cord has a bowline. Because I may shift Porch mode from one side to the other on any given hang and because a few extra feet of small cord does not bother me, I use 6-8 feet on all for corners.
With the Internal Pole Mod, I have never used my panel pulls.
Sorry, didn't address your question, but rather reviewed / sold the Internal Pole Mod.
Thanks. I plan to do the end pole mod myself, but in some situations may not carry the poles.
Bookmarks