Try these numbers. The picture you have looks more like a GE hang than the proper bridge hang.
Specific set up was. Ridgeline was 146", Baseline was 77" between the
innermost poles, Head was set to 49.5" high, Foot to 52" high. All of
these are Tensa4 measurements - and no I didn't set it this precisely
- did what worked then took a tape measure to it.
Head of the RR: The small amsteel continuous loop was put over the
closer of the head poles. The foot end: The triangular suspension
was put over the closer of the foot poles and then each side was
looped over that pole.
I tethered both ends, but the head only loosely. It seems to make
entry and exit more stable.
Bookmarks