Originally Posted by
Animal
I wanted a 13" pack length so I cut outside shaft one 9" center then two each 11" 12".
My inner shaft joints were cut 4" two inches glued in and two inch slip joint.
9" center had two you need making it 13" end to end.
If I do another one I'll make 1 1/2 slip joints with 1 inch glue joints.
I think that will work fine and get overall weight under 1.5 oz.
Also, next set I will use aluminum arrow inserts to attach the cords instead of dutch pieces.
Just enlarge hole in bottom of insert slightly to allow cordage to pass through, figure 8 a stop knot then house insert in shaft.
Overall packed length could be reduced to 11.5 inch and less than 1.5 oz each.
Shafts were 340 spine.
A mistake I made was not accounting for shock cord stoppers, I had to glue those in live.
I suggest cutting 1/2" piece of small diameter shaft and gluing it about halfway into the outside piece during glueup in order to have easy shock cord install.
Hope this helps.
Sent from my SM-G955U1 using Tapatalk
Bookmarks