Can somebody explain or show how to attach zipper pulls to continuous coil tape? I can't get the pulls on both sides. only one side of the zipper.,
Thanks
Can somebody explain or show how to attach zipper pulls to continuous coil tape? I can't get the pulls on both sides. only one side of the zipper.,
Thanks
The great folks at Dream Hammock did a good video.
Not sure where you are at in the DIY stage? But this techniques works well.
Ambulo tua ambulo.
That's a great video. Thanks for sharing
Sent from my iPhone using Tapatalk
image.jpg
Ok I got one on now I can't get the other one on so it zips correctly.
First time using zipper coil not a fan
image.jpg
I just can't seem to get it aligned
Remove second pull and try again.
Zipping the first pull to the end. It'll align/join the zipper. Then backtrack a few inches. Then slide the second pull on.
You need to keep alignment in check. Allowing any slack on either side of the coil will cause misalignment.
It is a subtle trick. But it is in the video.
Ambulo tua ambulo.
That's a great video by the Dream Hammock folks and thank you Gargoyle.
"If we lose the forests, we lose our only instructors. People must see these forests and wilderness as the greatest educational system that we have on the planet. If we lose all the universities in the world, then we would lose nothing. But If we lose the forests, we lose everything." -- Bill Mollison
Got it! The zip and unzip trick did the trick slipped right on with little effort.
Thanks
Bookmarks