Hi everybody.
I'm going to make a bridge hammock, and was wundering if anybody has made one en hexon 1.0?
Is it to flexible. ore do it work aswel as normal ripstop?
Advice pleace. .......
Hi everybody.
I'm going to make a bridge hammock, and was wundering if anybody has made one en hexon 1.0?
Is it to flexible. ore do it work aswel as normal ripstop?
Advice pleace. .......
Hexon 1.0 is too stretchy for a bridge imho. I prefer bridges out of a 1.6 ripstop or higher. Recently, robic 1.7 has been my favorite. I have used bridges made of hyperD 1.6, Hexon 1.6, Hexon 2.4 and a double layer 1.1.
Sent from my Pixel XL using Tapatalk
how about robic 1.0?
It would technically work, but I wouldn't recommend that. It would still have too much stretch, and you're setting yourself up to have to replace it sooner because of the fabric strength. I would be cautious of punctures because of how tight the fabric becomes. I know a few people who have used it in SUL setups, but it isn't ideal, could be even less ideal depending on how you choose to make the bridge.
Sent from my Pixel XL using Tapatalk
But if you are looking for WITCH fabric, you can't get any better than HEXon!
I am not that big of a person, but I would not go below a 1.6 material. I made one our of 1.6 Argon. I think there is a lot of stress on the material of a bridge.
Bookmarks